Overshoot

A small move in the opposite direction before the main move, like a wind-up; the start-of-move counterpart of Overshoot.

This is for a motion graphics video. Start the move in [scene] with "Anticipation" (also called a wind-up or back in): the object first pulls back a little in the opposite direction, then launches into the main move.
The pull-back belongs to the start, before the object leaves — it is the mirror of an overshoot, which runs past the target at the end.
Fit the wind-up and the move into [duration], keeping the pull-back small and unhurried so the launch that follows feels fast.

The object hits the target like a ball hitting the floor and rebounds with smaller hops until it rests; differs from Elastic by a hard stop at each contact.

This is for a motion graphics video. End the move in [scene] with a "Bounce" (also called a bounce ease or bounce out): the object hits its target like a ball hitting the floor and rebounds in smaller and smaller hops until it rests.
It should never pass through the target — each contact is a hard stop that turns it straight back, unlike an elastic ease, which swings past the target on both sides.
Fit the move and its hops into [duration], and make each hop clearly shorter than the one before.

Oscillates around the target several times with fading amplitude, like a stretched rubber band let go; more wobbles than Overshoot.

This is for a motion graphics video. Animate the move in [scene] with "Elastic" easing (also called an elastic ease or elastic out): the object snaps to its target and wobbles back and forth around it, each swing smaller, like a stretched rubber band let go.
It should cross the target several times — an overshoot passes it only once, and a bounce never passes it at all.
Fit the move and the wobble into [duration], and let the wobble die out fully before the end.

The motion plays forward then in reverse repeatedly; differs from Cycle Loop by not jumping back to the start.

This is for a motion graphics video. Repeat the motion in [scene] as a "Ping-Pong Loop" (also called a yoyo or boomerang): it plays forward to the end, then plays in reverse back to the start, and keeps going back and forth.
It should never jump — a cycle loop snaps back to the first frame and restarts, while this one retraces its own path.
Keep it going for [duration], with a soft turn at each end so the change of direction feels like breathing rather than hitting a wall.

A smaller supporting motion plays alongside the main one to add life without stealing focus.

This is for a motion graphics video. Add a "Secondary Action" to the main motion in [scene]: a smaller supporting movement that plays alongside it — a small accent, a blink, a flick — to give it more life.
It is a little gesture of its own, not a loose part dragged along behind the body (that is follow through), and it must never pull attention away from the main action.
Fit both into [duration], and let the small movement begin and end inside the main one.

One or two in-between frames distort or duplicate the subject along its path to fake motion blur during a very fast move.

This is for a motion graphics video. Use a "Smear Frame" (also called a smear or an elongated in-between) for the fast move in [scene]: for just a frame or two in the middle of the move, stretch the subject along its path so that it bridges the gap between the two positions.
The shape itself is redrawn — stretched, repeated as multiples, or trailed by motion lines — rather than blurred the way a camera would blur it, and the frames before and after stay sharp and undistorted.
Keep the whole move inside [duration] and very quick, so the smear is felt as speed rather than noticed as a shape.