Bounce

The object passes its target slightly and then returns to it; differs from Bounce in that it makes one pass and settles without hitting a floor.

This is for a motion graphics video. End the move in [scene] with an "Overshoot" (also called a back ease or back out): the object runs slightly past its target, then comes back and settles on it.
It should pass the target only once, with no wobble afterwards — a bounce hits the target and rebounds without passing it, and an elastic ease swings past it several times.
Fit the move into [duration], and keep the overshoot small so it reads as energy rather than a mistake.

Oscillates around the target several times with fading amplitude, like a stretched rubber band let go; more wobbles than Overshoot.

This is for a motion graphics video. Animate the move in [scene] with "Elastic" easing (also called an elastic ease or elastic out): the object snaps to its target and wobbles back and forth around it, each swing smaller, like a stretched rubber band let go.
It should cross the target several times — an overshoot passes it only once, and a bounce never passes it at all.
Fit the move and the wobble into [duration], and let the wobble die out fully before the end.

The motion repeats from the start; in a seamless loop the end state matches the start so no restart is visible.

This is for a motion graphics video. Repeat the motion in [scene] as a "Cycle Loop" (also called a loop or repeat): each time it reaches the end, it starts again from the beginning.
It should jump back to the start rather than play backwards, which would be a ping-pong loop. For a seamless loop, make the last frame match the first so the restart cannot be seen.
Keep it looping for [duration]; if each repeat should carry on from where the last one ended instead of returning to the start, make it an offset loop.

Starts slowly and accelerates toward the end, so the object leaves at full speed; opposite of Ease Out.

This is for a motion graphics video. Animate the move in [scene] with an "Ease In" (also called slow in, or accelerating): it starts slowly and keeps speeding up, so the object is at full speed when the move ends.
Do not soften the end — that is an ease out, the opposite curve, which starts fast and settles gently.
Fit the move into [duration]; it suits an object leaving the frame, since it is never seen stopping.

Slow start, fast middle, slow stop; differs from Ease Out by also accelerating gently at the start.

This is for a motion graphics video. Animate the move in [scene] with an "Ease In-Out" (also called easy ease, or slow in and slow out): it starts slowly, is fastest through the middle, and slows to a soft stop.
Both ends should be gentle — unlike an ease out, which starts at full speed and only softens the stop.
Fit the move into [duration], and pick a stronger curve if the middle should feel like a quick snap between two rests.